Get matched with top bathtub restoration pros in Madawaska, ME

Surprisingly, cleaning an air bath is almost as easy as relaxing in one. Most air baths have a self-cleaning or drying cycle to remove moisture from the inner tubing. This prevents mold and keeps the tub ready for your next soaking session. For deeper cleaning, use mild soap and a soft cloth to wipe the surfaces and periodically clean the air jets as the manufacturer recommends.

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

No. You should let the caulk completely dry before you expose it to moisture. It’s safest to wait at least a full day before showering where you’ve recently caulked. Showering before caulk is fully dry can lead to a poor seal, meaning water can seep into cracks and cause damage and mold growth. 

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.