Best roofers near Brooksville, ME

A metal roof can last anywhere from 15 to over 100 years, with an average of 50 years, depending on the material, installation, and environment. The specific metal is a key factor: aluminum roofs may last 20 to 45 years, while steel can last 30 to 60 years. Tin can last for up to 75 years, and more durable options like zinc, stainless steel, and copper can last from 80 to over 100 years. Factors that can shorten a metal roof's lifespan include living in a coastal region with corrosive salt air, improper installation (such as laying over old shingles), and failing to inspect and replace fasteners, which may wear out before the panels.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

If you choose tile for your roof, take the time to hire a true tile professional. Look at trusted online review sites to find a top-rated roofing contractor. This helps you zero in on great contractors while avoiding ones who bait and switch you with fluctuating bids.

After you’ve narrowed down a few great candidates with reasonable bids, there are some important questions to ask roofers before you hire. Be sure they are licensed, bonded, and insured before signing a contract. Once you find a roofer who checks off all your boxes, you’re ready to get your project started.

The most common slope range for roofs on houses in snowy areas is between 4/12 and 6/12, or 50%. A roof with a slope of less than 10%, or roughly a 2/12 pitch, won’t be effective at shedding snow. However, roofs that are too steep can allow large amounts of snow to build up and fall all at once, creating a hazard for those on the ground.