Get matched with top pool and spa technicians in Morningside, MD

For a fully-foamed hot tub, freezing typically occurs when the temperature drops below 28 degrees Fahrenheit and remains at or below this level continuously for a minimum of 36 hours. If your hot tub and pumps are still operational, however, the water circulates, and this continuous movement helps prevent freezing, even in very cold conditions. This circulation, along with the insulation provided by the foam, helps maintain the water temperature and prevent it from freezing during extended cold periods. Still, if you’re not planning to run it regularly, be sure to winterize the hot tub properly to prevent damage from freezing.

You can and should use a hose to fill a hot tub. There shouldn’t be anything special about the hose other than it shouldn’t be damaged. Kinks or leaks could slow down the filling process. Attach the hose to the nearest spigot and get the water flowing.

If you want to have a chemical-free spa, or if you are wondering how to keep your hot tub clean naturally, there are several options. Some individuals choose to run their hot tub without treatment at all and simply clean it more often (although you risk bacteria, fungi, and algae growth if you take this route); others use natural products like vinegar or Borax. Ozone, ultraviolet light, and electrolysis systems are also eco-friendly ways to have a clean hot tub without chemicals. Saltwater hot tubs are popular with people who are sensitive to chlorine, bromine, and other traditional hot tub chemicals.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.