Get matched with top floor polishers in Amherst, MA

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

If you’re looking for commercial cleaners, just check the label to find options that say they are safe for vinyl. Otherwise, homemade cleaners work great for vinyl plank flooring. Baking soda paste works well for spot-cleaning, and vinegar mixed with water is best for all-over cleaning. You can even clean your floors with plain water, which is great for everyday maintenance.

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.