Get matched with top masons in Choudrant, LA

A traditional rectangular brick that is used for siding, brick walks, and pathways is 8 inches long by 4 inches wide. If you are shopping for fire bricks, the standard dimension is typically 9 inches long by 4.5 inches wide.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

No, you shouldn’t lay bricks directly on dirt. While it might seem like a shortcut, it leads to a patio that shifts, sinks, and becomes a maintenance headache. Dirt expands, contracts, and erodes—none of which mix well with long-term stability. To build something that lasts, excavate the topsoil, compact a layer of crushed gravel, and add a coarse sand-setting bed. This layered base gives your bricks proper support, allows drainage, and helps block weeds from creeping through. Cutting corners here just means you’ll spend more time—and money—repairing your brick patio later.

Choose from an abundance of natural and synthetic options when perfecting your hardscape design. Stone veneer costs a bit less, holds up against the tests of time and weather, and also works best in curves and complex walls.

Natural stone, however, provides an organic look to a lawn while providing just as much strength as veneer. Don't forget you can chat with your mason about other common wall materials like brick, cinderblock, and concrete.