Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Magnolia, KY

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Magnolia, KY?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Magnolia

Avatar for Nesher Construction
Nesher Construction
New to Angi
Deck, Fence, Patio or Porch - Clean and Seal

Serving Magnolia, KY and surrounding areas

Approved

We are a Dunnville, Kentucky–based framing construction company dedicated to delivering strong, reliable structures built to last. With over five years of hands-on experience in residential and light commercial framing, we take pride in precision craftsmanship, efficient project timelines, and attention to detail on every job.\nFully insured for your peace of mind, we prioritize safety, professionalism, and clear communication from start to finish. Whether you’re building from the ground up, adding onto an existing structure, or tackling a renovation, we bring the expertise and work ethic needed to get the job done right.\nOur goal is simple: provide quality framing you can trust, backed by dependable service and a commitment to excellence in every project.

1 neighbors recently requested a quote
Showing 1-10 of 39
Deck Maintenance questions, answered by experts

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.

Yes, Ipe is more expensive than Trex decking—both in terms of materials and installation (plus, Ipe trees are endangered). On average, Ipe decking costs $10 to $25 per square foot, while Trex decking costs $5 to $12 per square foot. Because Ipe is harder to work with, the price of installation is higher, too. For Ipe decking, you’ll pay between $20 and $45 per square foot for labor. However, with Trex decking, the labor costs range from $8 to $22 per square foot.

The cost to repair a deck is between $900 and $3,500, depending on the cause and extent of the damage. For example, fixing a sinking deck caused by pest damage can cost between $200 and $600, while replacing sinking boards costs between $500 and $4,000.

Yes, deck pier blocks can be used as an alternative to traditional deck footings, especially for smaller or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks do not require digging or pouring. However, their use is dependent on local building codes. Some areas, particularly those prone to high winds, earthquakes, or hurricanes, may not permit the use of deck pier blocks. It is essential to consult your local building codes before choosing them for your deck project.

Applying too much sealer to a deck might seem like extra protection, but it can cause more harm than good. Wood is a porous material with a limited capacity to absorb liquids. When you go overboard with sealer, the excess can't soak in and instead forms a film on the surface. This leftover layer is prone to peeling, cracking, and trapping moisture, ultimately defeating the purpose of sealing in the first place. 

The Magnolia, KY homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.