Best floor polishers near Seneca, KS

Before installing shoe molding, evaluate redoing or refinishing any floors and painting your walls or baseboard before putting on your shoe molding. If you don’t already have baseboard trim, you should install that before adding shoe molding. Shoe molding is the final touch. Additionally, a carpenter or other professional that’s installing shoe molding might also give you a deal on installing crown molding and replacing other trim if you get them done at the same time.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

You can mop bamboo floors, but exercise caution to protect the material from excess moisture, which can seep into the bamboo, causing it to warp and well. Moisten a microfiber mop and wring it out until it’s just damp, or use a pH-neutral cleaner, as this will prevent damage to the bamboo fibers. Avoid harsh chemicals, like traditional floor cleaners. After cleaning, wipe the floor dry.

Yes, vinegar and water can strip wax. For a DIY wax stripper, mix about a quarter cup of vinegar with one gallon of warm water. You can also mix one cup of cream of tartar, one cup of white vinegar, and one gallon of water. Before using it on a large area of the floor, you should test it in an inconspicuous place to make sure it works like you want it to.