Get matched with top backsplash installation pros in Fort Scott, KS

Like any painted surface, tile paint can peel and chip over time. However, tile paint can become especially susceptible to peeling during periods of high humidity. Other sources of excess moisture will also cause tile paint to peel faster than normal. And if the tiles are in a high-traffic area, like the entryway floor, tile paint will chip and peel faster.

The choice of whether to tile or use an acrylic tub surround is up to you and can be based on a number of factors, including aesthetics, cost, waterproofing, ease of cleaning, and maintenance.

Tile is a beautiful, classic bathtub surround choice; while tile installation cost is higher, it’s customizable and offers visual appeal. Tile is also harder to clean and presents waterproofing problems because of grout lines. Acrylic surrounds can be more affordable, don’t require much maintenance, and are easier to clean. However, they aren’t usually as visually appealing and may need to be replaced if they become damaged.

Yes, you can install a backsplash directly onto drywall, provided the wall is properly prepped, clean, and dry. For best results, especially in kitchen areas, your walls should be made of moisture-resistant drywall, often called green board. If your current wall isn't moisture-resistant, it's recommended to replace it before installing the backsplash. For even greater protection against water damage, you can remove the existing drywall and install a tile backer board or cement board instead. While properly installed standard drywall is typically strong enough to support a backsplash, some local building codes may require water-resistant materials in kitchen areas, so it's a good idea to check.

Installing kitchen countertop tiles on a mold and moisture-resistant cement backer board is one of the best options. When fitted correctly on top of a plywood base, it’s stable and long-lasting. Old-fashioned cement board is economical, cuts neatly and easily with a circular or jigsaw, and screws into plywood without any difficulty.