Best water heater pros near Marcus, IA

The time it takes to install or replace a water heater depends on the type of heater and the complexity of the job. A professional can typically replace a standard tank-style water heater in one to three hours. However, if the work area is tight, such as a small closet or crawl space, the job could take four to five hours. Replacing an existing tankless unit takes about two to three hours, while upgrading from a tank-style to a tankless water heater is more complex and can take four to six hours. The project will take longer if you are switching fuel sources, such as installing a gas heater which can add about an hour to the timeline, or if the unit needs to be relocated.

No. Expansion tanks must be installed on the supply side (where heated water flows out) of the boiler. There’s also a list of other requirements for most boilers, including being above the pressure relief valves, being on the inner side of any circulator, and more. Your installation manual should have more information on expansion tank installation requirements and what sort of tank the system is made for.

Most hot water heater manufacturers recommend replacing the anode rod about once every three to five years. Anode rods sacrifice themselves by collecting iron, limestone, and other minerals that would otherwise corrode your hot water heater tank. This abuse wears them out long before your water heater does. Check the rod when you remove it and replace it if more than 50% of the metal has been consumed. Check the rod more frequently if you have hard water or use a water softener. 

Heat pump water heaters, also known as hybrid water heaters, are the most efficient types of water heaters—both in terms of carbon emission and energy efficiency. This type of water heater utilizes as little as half of the energy of a traditional water heater while releasing no direct emissions. Tankless water heaters are also extremely efficient, although slightly less so than hybrid heaters.