Get matched with top drywall pros in Hospers, IA

Generally, shower walls should not be installed over drywall because of the moisture issues this can cause. If you’re using a direct-to-stud shower kit, you need to remove the drywall before you can do the installation.

However, if you’re using a glue-up shower kit or stall, you can glue the shower walls directly to drywall. Be sure to install a moisture-resistant drywall or waterproof cement board.

You should wait at least 24 hours between each coat of drywall mud before sanding and adding another coat. This ensures the mud dries completely, although drying time depends on temperature, humidity, and the type of compound used. Lightweight muds dry faster, while heavier all-purpose compounds take longer. Always check for firmness and dryness before sanding or applying the next layer.

There are several benefits to wet-sanding drywall, but the main perk is that it produces far less dust than dry-sanding. As a result, wet-sanding poses fewer health risks and makes less of a mess in your home. Plus, damp sponges are less abrasive than sandpaper, so there’s a smaller chance of scratching or damaging the drywall paper. Wet-sanding also creates a smoother finish than dry-sanding.

Drywall does not necessarily need to be glued to the ceiling, especially when it is properly screwed or nailed into place. Drywall is typically attached to the ceiling joists using screws or nails, ensuring a secure and stable drywall installation. 

However, in certain situations where additional adhesion is required, construction adhesive can be applied in combination with screws or nails. This is often done for ceilings with specific acoustic or insulation requirements. It's essential to follow local building codes and best practices to determine if adhesive use is necessary for your specific project.