Get matched with top epoxy flooring pros in Garner, IA

If your garage floor is heavily soiled or stained, then it’s a good idea to powerwash it with a concrete cleaner before sealing. This process will remove dirt and debris to help the new sealer bond to the concrete properly, and it will also improve the look of your sealed garage floor. After power washing your floor, make sure you let the concrete dry completely before applying sealant, usually for 24 to 48 hours.

The best way to resurface a concrete porch is to clean and prep the surface, pour a layer of concrete on top, allow it to cure, then seal it. A concrete overlay provides a durable layer and enhances your porch's look. You can even choose a stamped overlay to make it look like stone or brick. To ensure structural integrity, repair concrete cracks before applying the new concrete. If the existing concrete is in significant disrepair, consider removing and replacing the concrete instead of an overlay.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Unlike paint, concrete stain won’t peel off. Instead, the color absorbs into the surface of this porous building material. While it doesn’t peel, the stain only penetrates the top layer of concrete, and as the top of the concrete eventually wears away, so will the stain. However, this process is much slower than paint peeling, especially on low-traffic surfaces.