Top-rated stucco pros.

Best stucco pros near Doon, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Doon, IA?

Select your specific project to find the pro for you.

Top-Rated Stucco pros in Doon - Updated Nov 2026

Stucco FAQs, answered by experts

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

Solid, unpainted stucco shouldn’t suffer damage from dots of glue used for this task. If the stucco is dirty, you may notice slight marks when you heat and peel the glue away, but these aren’t permanent.

However, not all stucco walls are solid stucco. Some are “faux” stucco with a foam backing. This kind of stucco veneer is more susceptible to damage, including damage from hot glue. We don’t suggest attaching anything to these kinds of stucco walls, so make sure you check the stucco type before starting this project.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

Costs range from $500 to $2,000, depending on the damage size and texture matching.

The Doon, IA homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.