Get matched with top buffing and polishing pros in Corydon, IA

How long it takes to complete stone restoration work will vary from home to home and project to project. Overall, a professional can complete a one-room project in one to two days. When vetting your local contractors, be sure to ask them how long they think the project will take to factor in any that could speed up or prolong the completion of the project.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

If you would rather use vinegar to clean the stone fireplace instead of dish soap, this mixture should work fine. Vinegar is slightly acidic, however, so it may etch some kinds of stone without quite a bit of diluting. For a stone fireplace, dilute it to about one cup of vinegar for every gallon of hot water. It’s a smart idea to test the diluted mixture in an inconspicuous area of the fireplace and watch for etching. You can use vinegar to clean quite a few different items around your home, and it’s especially good at removing stains.

Silestone® is a low-maintenance countertop material, but certain things, like strong chemicals and solvents, can cause damage. Abrasive scrubs can cause scratches, and products that contain oil or powder can leave a residue. Finally, avoid letting oven cleaner come into contact with Silestone® because it can cause discoloration.