Get matched with top deck cleaning pros in Commerce, GA

Yes, Ipe wood is a popular high-end choice for pool decking. It repels water and is naturally slip-resistant. It's not susceptible to mold, mildew, or rot, either, so it lasts longer and is cleaner and more hygienic than other popular decking materials. However, remember that due to its status, it is a very high-cost wood, and you might find that an alternative would serve you just as well for significantly less.

With proper installation and maintenance, a vinyl deck can last up to 30 years. Factors like regular cleaning, minimal wear and tear, proper installation, and the use of higher-grade materials can extend its durability. However, extreme weather conditions or neglecting maintenance might shorten its lifespan. Adhering to manufacturer recommendations for care and occasional inspections can significantly prolong a vinyl deck's longevity.

The best way to clean your decking is to clear debris from the gaps between the boards, sweep the surface, rinse it, apply cleaner, rinse again, and let it dry fully. A homemade deck cleaner made of two gallons of warm water and 1/2 cup vinegar is a simple cleaning solution for both wood and composite decking. You can sprinkle baking soda on any spots with mold or mildew, then scrub the area and rinse clean. 

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.