Get matched with top pool and spa technicians in Key Biscayne, FL

If you don’t clean your hot tub filters, they’ll build up dirt and grime, preventing them from filtering out contaminants like dirt and bacteria. The dirty water will then circulate through the filter and back into the hot tub, leading to dirty water, a damaged pump and jets, and low heat. This can lead to higher hot tub costs because you may have to pay for repairs.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.

Most hot tub motors can last between five and 10 years; however, hot tub motors can burn out sooner if the hot tub water is not maintained or if the motors themselves are not maintained or protected from the elements. Since hot tub motors (also referred to as spa pumps) power the jets and circulate the water, they are important for the functioning of your spa. Buying a quality motor, keeping the hot tub filter clean, and keeping the wet end of the motor wet and the dry end dry can help them last longer.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.