Get matched with top marble restoration pros in Bellview, FL

Deciding between marble and granite for kitchen countertops depends on your personal priorities, budget, and style. Both materials have similar costs for material and installation.

Marble offers a luxurious aesthetic and timeless beauty, but it is more expensive and requires more maintenance. It is susceptible to staining and etching from acidic substances like coffee, wine, or tomato sauce if spills are not cleaned up quickly.

Granite is highly durable, heat-resistant, and easier to maintain, making it a practical choice for busy kitchens.

Both materials should be sealed to protect against damage, but they can still be vulnerable to stains if spills are left on the surface for too long.

A water-based, low- or no-VOC sealer is typically a good choice for marble countertops. Choose a sealant that is certified safe for contact with food when applying to kitchen countertops. For high-traffic areas, look for formulas that have heat-resistant and acid-resistant features. While there are economical and convenient spray-on sealers, they don’t coat the surface as effectively as the ones you apply with a pad or brush. 

Professionals use resin fillers, diamond polishing pads, and sealants to restore the surface.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.