Get matched with top deck cleaning pros in Belle Isle, FL

Your deck may pop, and your neighbor’s deck may not for a number of reasons. Whether or not a deck pops will depend on how it was made, the conditions it’s exposed to, and the materials. Improper spacing is a common reason for increased pressure between deck boards. Moisture penetration is another.

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.

Yes, it is generally safe to have a fire pit on a deck, but you must adhere to building codes and take several safety precautions. For both built-in and freestanding models, you must use a heat-resistant barrier, such as a fire pit pad or heat shield, between the pit and the deck. Additionally, consider the weight of the fire pit and ensure your deck can structurally support it, reinforcing it if necessary. The fire pit must also be positioned a safe distance from your house, particularly from materials like vinyl siding, to prevent heat damage.

Before installing any materials under the deck for removing moisture, you should perform some prep work on the ground. Work the dirt under the deck to create a grade away from the home. A grade of at least six inches for every 10 feet works well. Do not leave a gap between the dirt and the home’s foundation where water could pool. Once you or a contractor regrades the dirt under the deck, you then can add materials over the top.