Get matched with top pressure washers in Bartow, FL

Even at the lowest setting, there’s always a risk that pressure washing might damage your shower or tub. Never use this technique if there’s pre-existing damage in your shower or tub, like peeling caulk, sealant, or cracked tiles. And skip this method entirely if there are any wood features present.

The recommended PSI (pounds per square inch) for cleaning vinyl siding can vary, so it's best to consult the manufacturer's guidelines. Generally, vinyl siding can handle high pressure, from 2,500 to 3,500 PSI. For comparison, more delicate materials like wood and aluminum siding should not face more than 1,500 PSI. To safely disperse the pressure on vinyl, use a tip with a wider spray span, such as a green (25-degree) or yellow (15-degree) nozzle. For routine cleaning of light dirt, a garden hose with a spray nozzle may be sufficient. Always exercise caution to avoid using excessive pressure that could damage the siding.

Not pressure washing your driveway can lead to several consequences that affect both its appearance and its structural integrity over time:  

• Reduced Curb Appeal: A dirty driveway covered in grime, stains, and mildew detracts from your home's overall appearance.  

• Safety Hazards: The buildup of algae, moss, and mildew creates slippery surfaces. When wet, it increases the risk of slips and falls for you, your family, and visitors.  

• Structural Damage: Dirt, debris, and organic growth can trap moisture against the driveway's surface. In colder climates, this moisture can freeze and thaw, leading to cracks and deterioration of the concrete or asphalt.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.