Get matched with top stucco pros in Westbrook, CT

Depending on the amount of damage, a stucco repair professional can repair your stucco siding in four to 12 hours. If you only have a few small cracks, that repair could take as little as one to two hours to repair. In contrast, if you have an extensive fix, like foundation or chimney repair, you can expect the process to take a bit longer. Always discuss your project expectations with your stucco repair expert.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.

It typically takes around 30 to 60 minutes for a window pro to replace one window in standard siding types, but a window in stucco will likely take a bit longer because of the density of materials. Custom architectural windows usually require a longer replacement process because of the additional fitting and securing required.