Best concrete resurfacing pros near Mosca, CO

Concrete resurfacing is the process of applying a new, thin layer of concrete over an existing concrete slab to enhance its appearance and durability. The terms 'concrete resurfacing' and 'concrete overlay' are often used interchangeably, though the exact meaning can vary between contractors. Generally, both refer to applying a layer of pre-blended concrete, typically between 1/4-inch and 1-inch thick. Some contractors may use 'overlay' to describe a thicker application that adds structural integrity, while 'resurfacing' might refer to a thinner, more cosmetic layer. This process is a cost-effective alternative to completely replacing the concrete, as it uses significantly less material than pouring a new 4-inch slab. Resurfacing also provides an opportunity to add new colors or stamped textures. Other names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

In almost all cases, yes, a damaged concrete driveway can be repaired, and the repair cost will be more affordable than a full replacement. Even major damage, like a sinking section of concrete, can be repaired by a professional using mudjacking or polyurethane concrete lifting and will average about half of the cost of a new driveway.

A concrete overlay on an existing slab can range from 1/4 of an inch to 2 inches thick, though a minimum of 2 inches is often recommended to ensure stability and quality. The ideal thickness depends on the condition of the existing concrete and the depth of any planned designs or imprints. Before applying the overlay, it's important to repair and clean the surface, then apply a primer. For specialized work like a stamped concrete overlay, hiring an experienced contractor is recommended to determine the correct thickness and ensure the new layer isn't too high or heavy. For context, most standard concrete slabs are between 4 and 6 inches thick.

While you don’t technically need to grind concrete before resurfacing, it is very helpful. Grinding creates a rough, porous surface on the concrete, which gives the resurfacing material something to latch onto. Grinding your concrete before resurfacing can ensure that your resurfacing material lasts longer, reducing additional concrete resurfacing costs down the line.