Get matched with top concrete driveway pros in Eagle, CO

The ideal frequency for pressure washing depends on the surface being cleaned and your local environmental conditions. For a home's exterior with siding that is safe to wash (such as vinyl, cement, or aluminum), a full wash once or twice a year is a good guideline to remove accumulated dirt, grime, mold, and mildew. You may need to wash more frequently if you live in an area with heavy rain or snow, near a dirt road, or if you notice excessive buildup. Other surfaces have different schedules; for example, a frequently used driveway may need cleaning more often, while outdoor patio furniture might only need to be washed every few years. Use your discretion based on how dirty the area gets.

The average cost to pressure wash a house is around $310, with typical prices ranging from $200 to $420. However, the total cost can vary widely, from $200 to $750. Power washing, which uses heated water, may cost between $250 and $400 per project, with an average of $200 to $300 for a 2,000-square-foot home.

Key factors that influence the final price include:

• The size and height of the house (a multi-level home costs more than a single-story one).

• The complexity of the job and accessibility of certain areas.

• Geographic location.

• Equipment and hourly labor costs.

Hiring a professional is often recommended as they bring their own equipment and cleaning solutions. Experienced professionals know how to complete the job effectively without causing damage to your siding, gutters, or landscaping, which can be a risk with high-powered water jets.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.