Get matched with top roofers in Collbran, CO

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Architectural shingles typically last between 20 and 30 years. While some manufacturers provide warranties for 30 to 50 years, particularly for extreme weather, achieving such a long lifespan is uncommon. The actual life of your shingles can be shorter if you live in an area prone to strong winds, hailstorms, or other severe weather. To avoid the risk of roof failure and costly water damage from leaks, it is recommended to replace your roof before it reaches the end of its expected life. Scheduling regular roof inspections every few years is a good way to assess your roof's condition and determine the best timeline for replacement.

No, you do not need gable vents if you have a ridge vent. In fact, gable vents would actually interrupt the process that ridge vents are set to conduct. You would be better off to decide between the two depending on your home’s needs.

You should avoid choosing a metal roof if your home has a weak structural support system, as metal roofs can be heavier than roofs made of other materials. If you're in a region prone to frequent hailstorms or high winds, you also need to be aware that denting may occur.