Top-rated pool and spa technicians.

Best pool and spa technicians near Brush, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Brush, CO?

Select your specific project to find the pro for you.

Top-Rated Pool and spa technicians in Brush - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or ServiceHot Tub or Spa - Repair or ServiceIn Ground Swimming Pool or Accessories - Repair or Service+6 more

Serving Brush, CO and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Ripple Pool and Hot Tub, LLC
New to Angi
Hot Tub or Spa - Repair or ServiceSwimming Pool - Clean and MaintainSwimming Pool - Opening & Closing Service

Serving Brush, CO and surrounding areas

In business since 2021

Free estimates

Credit card accepted

Ripple Pool and Hot Tub LLC is a company committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers interests, and make their concerns the basis of our business.

Pool and Spa Servicing FAQs, answered by experts

Generally, it is more cost-effective and energy-efficient to leave your hot tub on all the time rather than turning it on and off. Reheating a hot tub from a cold temperature consumes a significant amount of energy, so maintaining a constant temperature is usually more economical, especially with frequent use.

For daily or weekly use, it's recommended to keep the water at a constant, reduced temperature, such as between 80 and 95 degrees Fahrenheit, and then increase it to your desired temperature before getting in. If you know you won't be using the hot tub for an extended period, you can lower the temperature to save on energy costs. However, if you use it very infrequently, you can turn it off completely, as long as there is no risk of the water freezing.

Hot tub heaters typically last seven to 10 years, though some might only last five years if not properly maintained. You can maximize your hot tub heater’s lifespan by ensuring the water’s pH level is properly balanced.

Follow these general safety tips for spas and hot tubs:

  • Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

  • Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

  • Don’t use the hot tub or your pool during a thunderstorm. 

  • Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

You’ll know you need to replace the pump in your hot tub if you hear loud or unusual noises when the machine is running or notice a significant decrease in water pressure. A leak or altogether failure of the hot tub may also indicate a problem with the pump, but you’ll need a professional to investigate the source of the issue.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

The Brush, CO homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.