Best stucco pros near Burney, CA

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

The average cost to repair stucco is about $1,600, with projects ranging from $250 for minor fixes to $6,700 for extensive work. The price is often calculated per square foot, typically costing between $60 and $120. Some professionals may charge an hourly rate of $40 to $50. The final cost depends on the extent of the damage, the type of stucco, your home's location, and whether there is underlying damage that also needs to be addressed.

Costs for specific repairs vary:

• Cracks: $8–$20 per square foot

• Holes: $250–$450 per hole

• Water damage: $30–$50 per square foot

• Chimney repair: $60–$120 per square foot

• Recoating: $4–$5 per square foot

While you may be able to patch small cracks yourself, it is recommended to call a professional for major repairs to ensure the job is done correctly.

Most homeowners can remain in their homes during stucco removal, but expect noise, dust, and limited access to certain areas. For extensive projects or if hazardous materials are present, temporary relocation may be recommended for safety and comfort. Before removal begins, seal off the work areas and use air purifiers to minimize the spread of dust.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.