Get matched with top toilet pros in Grannis, AR

Technically, you can put an elongated toilet seat on a round toilet, but it’s not a good idea. Elongated toilet seats are a few inches longer than round toilets, so they will hang over the front edge of your toilet, which isn’t appealing. Additionally, an unsupported toilet seat or portion of a toilet seat is more likely to crack and shift, which could result in injury to whoever uses the toilet. Always match your toilet seat style to your toilet, or replace the toilet entirely if you’re looking to switch styles.

While you shouldn’t increase the flow of your low-flow toilet by adjusting the water level in the toilet bowl set by the manufacturer, you can make the flow as efficient as possible by ensuring the rim jets under the rim are unobstructed. To do this, use a mirror to look under the rim and scrub them with a toothbrush or a small wire to clear any debris stuck in the holes. You can also watch for leaks, make sure the internal components are in good shape, and replace them if necessary.

While you don’t have to run out and immediately buy a new toilet at the first sign of a clog, if the toilet keeps clogging because it’s a low-flow or poorly designed model, a new toilet may be the way to go. If your toilet keeps clogging, you can try using less toilet paper, adjusting the fill valve, checking the toilet vent pipe on the roof, and using a toilet auger to make sure nothing is stuck in the pipe or trap.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."