Get matched with top pressure washers in Dover, AR

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Whether you need to winterize your pressure washer depends on where you store it. If you can keep it in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, if the machine will be stored in freezing temperatures, any liquid left in the water pump can freeze, expand, and cause severe damage. To prevent this, add antifreeze to keep it in good condition. While some suggest emptying the machine with compressed air, this can be a tedious process that may not fully drain the liquid. Regardless of storage conditions, it is also good practice to empty the gas chamber and refresh the oil before winter storage.

The best soap for a pressure washer is a mild multi-purpose cleaning agent. Mild dish soap works, but make sure to dilute it with a 1:4 ratio of soap to water to avoid clogging your machine. Sometimes you won’t even need a detergent when using a pressure washer. It all depends on how grimy your furniture is to start with.

Much like wood siding, it can be dangerous to use a pressure washer on composite siding. While normally durable, composite siding isn’t made to stand up to higher pressure settings. It also makes it very easy to damage the paint or finish on the siding. Some professional power washing companies may take the job on, but we recommend avoiding it, especially as a DIY project with a rented pressure washer.