Get matched with top pre-made cabinet pros in Centerton, AR

The 1/3 rule is a design guideline used by interior designers and cabinet installers to select appropriately sized pulls for cabinets and drawers. The rule suggests that for a balanced and cohesive look, a cabinet pull should be approximately one-third the height of the cabinet door or one-third the width of the drawer face. This guideline helps create a symmetrical appearance because the human eye tends to follow the length of the pull across the cabinet face.

While the 1/3 rule is a helpful starting point, it is not the only option. If a measurement falls between available pull sizes, it's generally best to size up. For an ultra-contemporary aesthetic, you can also opt for full-width pulls that span the entire drawer.

If your cabinets don’t reach the ceiling, you can extend them higher, adding visual interest, privacy, and storage space to your kitchen. Depending on the height of your ceiling, you may want to extend the structure of the cabinets and install longer doors to make each individual cabinet taller, or you could add additional cabinets above the existing ones. Either option is cheaper and easier than installing entirely new cabinets.

It depends on whether you buy pre-made stacked cabinets or construct them from scratch. If you build added cabinets from scratch, you can expect it to take several hours or days to build each one and then another two to three days for installation. Then, after painting your new cabinets, you should allow a few weeks for the paint to dry thoroughly before installing them over your existing cabinets.

There are several ways to save money and keep costs down when building an outdoor kitchen. Building on an existing patio can reduce the cost of a new foundation, especially if it's close to the house. You can also save on utility line installation by opting out of a sink and using a built-in propane or charcoal grill. If you have the skills, tackling parts of the project yourself—like building or finishing cabinets, installing fixtures, and constructing seating—can lead to significant savings. Reusing appliances you already have is another great way to cut costs. Finally, consider starting small with just the essential components and adding more features over time as your budget allows.