Best pressure washers near Augusta, AR

Whether you need to winterize your pressure washer depends on where you store it. If you can keep it in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, if the machine will be stored in freezing temperatures, any liquid left in the water pump can freeze, expand, and cause severe damage. To prevent this, add antifreeze to keep it in good condition. While some suggest emptying the machine with compressed air, this can be a tedious process that may not fully drain the liquid. Regardless of storage conditions, it is also good practice to empty the gas chamber and refresh the oil before winter storage.

One of the best ways to save money on deck cleaning services might seem counter-intuitive: pay for cleaning annually rather than waiting until it’s necessary. Routine deck maintenance can help you avoid stains and mold growth, both of which can detract from the appearance of your deck and limit its lifespan. Annual cleaning and resealing will keep your deck looking new for longer, adding utility to your yard and improving the overall appeal of your home and its value. You can also save money by coupling deck power washing with other outdoor cleaning services, like fences, patios, and walkways.

You could void your roof warranty using a power washer if you have a newer roof. With an older roof, you could knock loose older shingles. On the other hand, some people safely use a pressure washer to remove moss from a metal roof. Although you may want to use a pressure washer, the truth is that you probably don’t need it to knock moss loose. A garden hose and brush will do the job just fine and in a safer manner than a pressure washer.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.