Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Tyler, AL

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Tyler, AL?

Select your specific project to find the pro for you.

Verified Reviews for Epoxy Flooring Service pros in Tyler, AL

*The Angi rating for Epoxy Flooring Service companies in Tyler, AL is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Epoxy Flooring Service needs.

*The HomeAdvisor rating for Epoxy Flooring Service companies in Tyler, AL is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Epoxy Flooring Service needs.

Last update on March 19, 2026

Find Epoxy flooring pros in Tyler

Avatar for Hightide Color Coatings
Hightide Color Coatings
4.0(
2
)
Concrete Finishing, Overlays & Coloring - ApplyConcrete Floor Coating-Apply

Serving Tyler, AL and surrounding areas

In business since 2003

Free estimates

Credit card accepted

"i have no complaints they did a great job and if i ever need anything else done in the future iâ ll give them a call"
Response time8 hrs
Response rate92%
Recommended by50%of homeowners
Request Quote
Avatar for Miruscapes
Miruscapes
5.0(
1
)
Concrete Finishing, Overlays & Coloring - Apply

Serving Tyler, AL and surrounding areas

In business since 2020

Free estimates

Emergency services offered

Miruscapes is more than just lawn and landscaping, we are your complete turf and property management solution. From basic lawn care to advanced turf management and everything in between, Miruscapes is here to serve you. Your property becomes our passion!

Recommended by100%of homeowners
Request Quote
Showing 1-10 of 28
Epoxy Flooring questions, answered by experts

The cost to replace a driveway coating ranges from $275 to $850, or $550 on average. Naturally, larger driveways cost more than smaller driveways. The type of driveway sealant and the number of coats also impact the cost. Coal tar sealant costs the least, while latex acrylic sealant costs the most. Oil-based sealants fall in the middle. 

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Epoxy tends to be the most durable concrete finish, holding up on garage and shop floors for years. Epoxy seals the slab's surface, will run into any cracks and crevices, and can help to level the surface, so it tends to be a durable finish for most applications. The downside to epoxy is that it can be difficult to remove once applied.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

Yes, you can seal an old concrete floor as long as you remove stains and repair damage before sealing. Remove everything from the garage and clear the floor throughout with a concrete cleaner and power washing. Fill in cracks larger than 1/8 of an inch wide and remove all grease and rust stains before sealing. Make sure your concrete is fully dried before applying sealer.

The Tyler, AL homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles