Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Moran, WY

Enter your zip and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Moran, WY?

Select your specific project to find the pro for you.

Verified Reviews for Bathtub Restoration pros in Moran, WY

*The Angi rating for Bathtub Restoration companies in Moran, WY is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Bathtub Restoration needs.

*The HomeAdvisor rating for Bathtub Restoration companies in Moran, WY is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Bathtub Restoration needs.

Last update on December 05, 2025

Find Bathtub restoration pros in Moran

Avatar for American Tubs....

American Tubs....

2.33(
3
)

American Tubs....

2.33(
3
)
Customers say: Terrific value
13 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

Refinishing a bathtub is a project you can do at the same time as refinishing a porcelain sink. If your tub is the same age as your sink, consider getting a quote. Most homeowners spend about $480 on the cost of refinishing a bathtub, but it ranges between $335 and $630, depending on the size, style, and material of the tub.

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Refinishing a bathtub takes about two to four hours, but let the surface set for another 24 to 48 hours before using it again. Once it's set, your tub should last for 10 years or more. Ventilating the bathroom during this time is key for safety. In comparison, it takes about four hours to install a new bathtub.

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.

The Moran, WY homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles