Get matched with top stucco pros in Basin, WY

Yes, you can apply the stucco yourself, but it is a time- and labor-intensive project, especially on the exterior of a whole house. DIY stucco is better suited for repairing stucco siding or siding a smaller building, such as a shed or garage. Since most of the cost of stucco siding goes to labor, you can cut down significantly on the total if you’re up for the challenge.

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.

The best way to assess that your stucco needs repair is to inspect it, both visually and physically. If you notice cracks, chips, or staining, that’s a good indication that your stucco could use some TLC by a professional. Additionally, if you touch an area that feels soft and has a little “give,” you should consider repairing it as soon as possible to avoid further damage, both to additional stucco spots and to your home’s structure. 

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.