Q: Will ammonia damage an acrylic tub?

• <div><p>Ammonia is a powerful household cleaner, but don&rsquo;t use it for your acrylic tub. Ammonia or cleaners containing this ingredient can break down the surface of the acrylic bathtub and leave it with permanent damage. Instead, try a gentler store-bought acrylic tub cleaner, or a homemade baking soda cleaner.</p></div>

Q: How do you prepare a shower before caulking?

• <div><p>Before you begin caulking a shower, you&rsquo;ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to <a href="https://www.angi.com/articles/how-clean-mold-mistakes-avoid.htm">get rid of the mold</a>, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter&rsquo;s tape&mdash;one above the joint where you&rsquo;re caulking and another below it.</p></div>

Question 1

What is the difference between bathtub refinishing and reglazing?

Accepted Answer

•

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.

Question 2

Is it less expensive to resurface or replace a bathtub?

Accepted Answer

•

Resurfacing a bathtub is less expensive than replacing one. Resurfacing a tub costs about $330 to $630, depending on the material, while replacing a tub costs an average of $4,150. But remember that resurfacing is a temporary solution for a worn-out tub, and you may need to refinish a tub every few years to keep it looking new.

Question 3

How do I know if my tub is fiberglass or acrylic?

Accepted Answer

•

There are a few ways to check whether your tub is fiberglass or acrylic. If your tub is a color other than white, then your tub is likely acrylic (as fiberglass tubs are usually white). Check to see if there is discoloration on the bottom of the tub, because if it’s yellowed, then you can be fairly sure it’s fiberglass.

Also, fiberglass tubs have thinner edges and are cool to the touch. Acrylic, on the other hand, is either room temperature or warm to the touch.

Question 4

Will ammonia damage an acrylic tub?

Accepted Answer

•

Ammonia is a powerful household cleaner, but don’t use it for your acrylic tub. Ammonia or cleaners containing this ingredient can break down the surface of the acrylic bathtub and leave it with permanent damage. Instead, try a gentler store-bought acrylic tub cleaner, or a homemade baking soda cleaner.

Question 5

How do you prepare a shower before caulking?

Accepted Answer

•

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.