Get matched with top stucco pros in Middlebourne, WV

One of the most significant downsides to stucco is the installation cost, which is higher than that of many other siding options because getting it to look clean and professional is a labor-intensive process. Stucco can also absorb water, making it an unsuitable option for siding in areas that see excessive rainfall. Finally, stucco can crack and chip, especially in extreme weather, and repairs are not only challenging and require help from a professional who does stucco, but can get expensive.

Stucco is very challenging to DIY, so it’s always best to leave the work to professional stucco contractors. The same recommendation applies to painting a stucco house, which should be left in the reliable hands of a professional exterior painter. Inexperienced DIYers can make several critical mistakes during stucco application, such as:

• Failing to apply sufficiently thick layers for longevity and water resistance

• Uneven application

• Uneven texture across the exterior

• Mixing the stucco improperly, leaving a weak structure

• Failing to texture properly in between coats, leading to cracking and chipping

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.