Get matched with top deck cleaning pros in Daniels, WV

Before installing a new railing, check the condition of the deck frame and joists, especially around the perimeter where posts attach. If boards are loose, soft, or show signs of rot, the structure may need repair. A deck pro can inspect your framing to confirm it meets load-bearing requirements.

The most likely causes of a deck leaning to one side are damaged deck posts, soil erosion, and inadequate deck footings. If you’re not sure about the exact cause, the best option is to call a contractor who can build a deck to inspect the damage and recommend the best way forward.

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.

When installing deck boards, screws are generally a better option than nails. Screws offer superior holding strength over time, keeping the boards securely in place. In contrast, nails are more likely to pop out, which can create a tripping hazard. While you can use either, we recommend using 3-inch galvanized deck screws. To minimize the risk of cracking the wood, it's a good practice to drill small pilot holes before driving the screws into the deck joists.