Get matched with top bathtub restoration pros in Beaver, WV

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

You can use other ways to seal the space where your tub and the bathroom tile meet. Using sealant tape, epoxy sealer, and spray foam can be just as effective as caulking your bathtub. When using alternatives to caulk, the one that is best for you depends on your preferences. 

Sealant tape takes less time and effort to use, which is why some homeowners prefer it. Meanwhile, epoxy sealer creates a smooth and glossy finish that can complement your bathroom. Lastly, spray foam is waterproof and can act as insulation for your tub.

As with any project, refinishing your bathtub presents pros and cons to consider, such as:

Pros

• The job is typically quick, and your tub is ready within 48 hours.

• Your bathtub looks new.

• You don’t need to tear out the old tub and replace it with a new one.

• You can customize it with the color of your choice.

• You can’t tell the bathtub has been refinished.

Cons

• Refinished bathtubs can be slippery.

• Not all refinishing products are created equal.

• You need to wait up to 48 hours before using the bathtub.