Get matched with top flooring contractors in Winneconne, WI

The average cost to install an epoxy garage floor is $2,514, with typical projects ranging from $750 to over $5,716. On a per-square-foot basis, you can expect to pay between $3 and $12. Several factors influence the total cost, including the total square footage, required surface preparations, the type and thickness of the epoxy, design complexity, decorative options, and labor costs. For example, an epoxy floor for a one-car garage may cost between $720 and $2,900, while a two-car garage can range from $1,100 to $4,300. Adding decorative elements like flakes can cost about $10 per 250-pound bag, and choosing a metallic epoxy can increase the price to between $5 and $12 per square foot. With proper care and maintenance, a well-installed epoxy floor can last for 10 to 20 years.

Yes. When installed properly, the strong adhesive on carpet tiles keeps them in place while also allowing homeowners the flexibility to peel up an individual tile and replace it if they need to. It’s important to keep in mind that the adhesive on your carpet tiles may take some time to cure, so it’s best to leave them alone for a couple of days after you first install them.

Carpet stretching can be a worthwhile investment to increase the lifespan of your carpet and eliminate unsightly wrinkles, ridges, and ripples. For an older carpet that is in relatively good condition aside from some wrinkling or bubbling, restretching can make it look like new and extend its life by at least a couple of years. You should consider restretching when you notice looseness or other related issues.

However, it's important to note that stretching will not fix issues like stains, wear in the pile, or discoloration. Consider replacing the carpet instead if the repair cost is more than 50% of the price of a new one. Additionally, if your carpet is past its expected lifespan of five to 15 years, or if it has been stretched multiple times already, replacement is likely a better option.

Dry rot or severe water damage may warrant a replacement, but you don’t always need to replace damaged subflooring. If your subfloor has warped because it was installed incorrectly, you can sometimes shim the panels (in other words, add a thin, wedge-shaped piece of wood to level the surface). If your subfloor bows upward, you may be able to sand it down at the joist so it’s level, depending on the extent of the damage.