Top-rated sandblasting pros.

Get matched with top sandblasting pros in Neopit, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your sandblasting service project in Neopit, WI?

Select your specific project to find the pro for you.

Find Sandblasting pros in Neopit

Avatar for Matthew Moss Painting
Matthew Moss Painting
3.7(
3
)
Exterior Surfaces - SandblastingExterior Surfaces - Sandblasting - For Business

Serving Neopit, WI and surrounding areas

In business since 1990

Emergency services offered

Credit card accepted

Interior painting, exterior painting, Log Cabin Staining sheetrock repair, carpentry work, staining, concrete painting, handyman work, pressure washing, corn cobb and walnut shell blasting, cedar roof cleaning and stain & wood floor re-finishing. Additional phone number - (218) 851-4078

Additional Photos
Additional Photos
Before
After
Before

+24

Recommended by66%of homeowners
Request Quote
Sandblasting Services questions, answered by experts

The cost of sandblasting depends on the scope of the project, the surface type, labor, and equipment required. Services typically cost between $50 and $80 per hour, though most professionals charge by surface area at a rate of $1.50 to $7 per square foot. Total project costs can range from $700 to $12,500, with an average homeowner spending around $3,200 to sandblast a 1,000-square-foot surface.

You can concrete can be done when it’s wet or dry. However, it’s safer when wet, as harmful dust and chemicals are present. Sanding it when dry is faster, but you’ll agitate more dust and chemicals, meaning you’ll need to be more careful.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

Yes, many professionals use dustless or water-based blasting methods for reduced environmental impact.

Sandblasting is useful when you need to strip material off a hard surface. Common reasons to sandblast are to remove paint, rust, or get a surface ready for a new material. You aren’t limited to surfaces like walls either—you can sandblast rusted tools, bicycle frames, cement, bricks, and many others. If what you’re sandblasting is still structurally sound, sandblasting can be a fast and inexpensive way to revive the original material. 

The Neopit, WI homeowners’ guide to sandblasting services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles