Get matched with top brush chipping pros in Melrose, WI

The best way to clean an overgrown yard is to create a multi-stage game plan, from clearing out the debris to cleaning up the edges around hardscaping and landscape curbing. Get rid of yard debris like worn furniture and broken tools first, then start trimming and raking what’s left. Mow the grass, trim the hedges, and rake leaves away. Once that’s complete, move on to more detailed work, like pulling weeds and replanting gardens.

If you want to remove a bush that’s located on top of utility lines, you’ll need to call your local utility company to determine the best course of action. If you can’t dig out your stump its roots, cutting a bush off at ground level might be the best you can do. Adding a planter over top of the cut branch or planting something else around the stump can cover the area while the stump decomposes.

While tipping junk haulers is not required or expected, it is a greatly appreciated gesture for a job well done. Many junk removal companies state that tips are welcome but not mandatory. A good rule of thumb is to tip between 10% and 20% of the total bill, or a flat amount of $10 to $20 per worker. For exceptional service, a tip of $20 to $50 for the entire crew is also appropriate. It is often best to give cash directly to each worker at the end of the job.

Consider tipping if the crew:

• Goes above and beyond your expectations.

• Handles heavy, bulky items or navigates difficult spaces like tight hallways or stairs.

• Works in inclement weather or deals with potentially hazardous materials.

• Takes extra care to protect your home and property.

• Accommodates a last-minute scheduling change.

Depending on the method you choose to remove grass, it may or may not matter whether the grass is wet or dry when you perform the task. A dryer lawn will be easier to negotiate with a sod cutter, especially if you're not planning to reuse the turf. However, using a shovel by hand might be a little easier if the ground is slightly damp but not so much that it sticks to the tool.