Top-rated concrete mudjacking pros.

Get matched with top concrete mudjacking pros in Abrams, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete mudjacking project in Abrams, WI?

Select your specific project to find the pro for you.

Find Concrete mudjacking pros in Abrams

Avatar for Raiserite Foundation Pier System, Inc.
Raiserite Foundation Pier System, Inc.
4.0(
12
)

Serving Abrams, WI and surrounding areas

In business since 1974

Free estimates

Warranties offered

"They work was done exactly when they said they would do it, at the exact price they quoted.The results were very good. I would be willing to use their service again if sections of concrete needs to be leveled. I feel comfortable recommending them to friends and relatives."
Egress Window
Egress Window Install
Interior waterproofing
Waterproofing
Polyurethane Foam Concrete Raising

+4

Response time2 days
Recommended by81%of homeowners
Concrete Mudjacking questions, answered by experts

Generally speaking, push piers—or steel piers—are the best option for underpinning, as they reach down to solid bedrock to find support for your foundation rather than relying on soil, which could be subject to the same issues as the soil directly below your foundation. However, the best underpinning method for your home depends on your location, how far down the bedrock is, and the type of soil in your area. Helical piers are usually the best option for sandy soil or in areas where the bedrock is too deep to use steel piers.

Polyjacking and mudjacking can both be effective solutions for sinking concrete, but they have key differences. Polyjacking, which uses expanding polyurethane foam, is often considered a better option because the foam is significantly lighter than the cementitious material used for mudjacking. This reduced weight puts less pressure on the underlying soil and lowers the risk of future sinking. Polyjacking is suitable for any sinking concrete slab, while mudjacking is typically only recommended for non-structural concrete, such as sidewalks, patios, pool decks, and driveways. The primary drawback of polyjacking is its cost, which can be up to four times higher than mudjacking—as much as $25 per square foot compared to a maximum of about $6 per square foot for mudjacking.

Mudjacking typically takes 24 to 72 hours (one to three days) to dry and cure completely before you can resume normal use. The total drying time can vary depending on the size of the project. Because the slurry mixture contains cement, it needs to harden fully to prevent the concrete slab from shifting under added weight. You should avoid walking on the concrete or placing heavy items like furniture or vehicles on the surface until it has fully set. Your concrete contractor can provide a precise timeline. As a point of comparison, if you opt for polyjacking, the polyurethane foam can dry in minutes, but it's recommended to wait about an hour before use.

Mudjacking restores level surfaces, prevents further damage, and is more cost-effective than a full replacement.

Mudjacking can be an expensive foundation repair process, but in many cases, it’s well worth the investment. This is especially true if you’re lifting a portion of sunken foundation slab back into place. In that case, mudjacking can help avoid major structural damage and even home collapse by restoring the integrity of your structure with minimally invasive procedures. Mudjacking a concrete patio, walkway, or sidewalk can be worthwhile because it removes tripping hazards and makes your outdoor area more aesthetically appealing.

The Abrams, WI homeowners’ guide to concrete mudjacking services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"