Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Bridgeport, WA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Bridgeport, WA?

Select your specific project to find the pro for you.

Find Deck cleaning pros in Bridgeport

Avatar for JBC Group Solutions Inc
JBC Group Solutions Inc
4.0(
4
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Bridgeport, WA and surrounding areas

In business since 2007

Emergency services offered

"They did a real good job. They were real professional. We can now open the garage door from the inside of the house and now it is so smooth that we have to check to see if we hit the button to open it or close it.  Before we used to know when it was opening or closing because it used to make a noise. It helps when you move to a city where you are new. "
Custom Staircases
Custom Exterior Restoration
Custom Bathrooms
Recommended by75%of homeowners
starz unique
New to Angi
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Bridgeport, WA and surrounding areas

In business since 2014

Free estimates

Credit card accepted

I am a professional business owner who values honesty and integrity and treats your property as if it were my own. I offer a variety of lawn care services that are customizable to each individual project. I pride myself on the quality of my work as well as my commitment to outstanding results. I look forward to building lasting relationships with my clients and guarantee your satisfaction!

Deck Cleaning questions, answered by experts

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

DIY staining or painting is manageable with proper preparation, including safety measures, necessary tools, and adherence to safe weather conditions for application.

Typically, most residential wooden decks are designed to support approximately 40 pounds per square foot, including the deck’s weight and any items placed on it. While this is fine for typical use, it is usually not enough to hold the weight of a hot tub filled with water and people. To safely support a hot tub, your wood deck will likely require reinforcement. Therefore, it’s best to have a contractor or a structural engineer assess it before hot tub installation.

Yes, Ipe wood is a popular high-end choice for pool decking. It repels water and is naturally slip-resistant. It's not susceptible to mold, mildew, or rot, either, so it lasts longer and is cleaner and more hygienic than other popular decking materials. However, remember that due to its status, it is a very high-cost wood, and you might find that an alternative would serve you just as well for significantly less.

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

The Bridgeport, WA homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.