Get matched with top buffing and polishing pros in Marlboro, VT

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The best cleaning method to use for your project will depend on the specifics of that project. However, sandblasting does come with the risk of damaging the surface you’re trying to clean. One safer alternative to sandblasting is laser cleaning, which can remove many of the same contaminants with a lower risk of damage and a lower overall cost.

Both buffing and polishing increase the longevity of your floors by removing scratches and buildup, but they are different processes. Polishing removes the top layer of your floor, removing surface-level scuffs and scratches. Buffing your floor involves filling the scratches and scuffs with a buffing solution. No matter which method you choose, you can rest assured that both techniques will leave your floor looking shiny and new.  

Silestone® isn’t recommended for outdoor use because UV rays can damage the surface. Long-term exposure to direct sunlight can cause discoloration. Instead, choose an outdoor-friendly countertop material like tile, concrete, stainless steel, or natural stone. If you do choose a natural stone, make sure you either seal it or avoid highly porous stones. For example, choose soapstone over marble.