Top-rated welders.

Get matched with top welders in Locust Hill, VA

Enter your zip and get matched with up to 5 pros

Need a pro for your welding project in Locust Hill, VA?

Select your specific project to find the pro for you.

Find Welders in Locust Hill

Avatar for RED SUN WELDING CO, LLC
RED SUN WELDING CO, LLC
New to Angi
Metal Structure or Object - Weld or Cut

Serving Locust Hill, VA and surrounding areas

Approved

Emergency services offered

Small jobs welcome

Offers commercial services

Im a mobile welder, welding for over 10 years. I’ve worked on boiler units, pipes, structural, new build or repair. No job is to big or small. I can come to you or you can come to me. I take pride in my work from the fit up to the final touch ups. I hope to do some work for you. On this site they charge me a 25 to 30 dollar fee for leads to a job so you can find me through my website redsunweldingco.com

Grady's Painting Plastering/Construction
2.0(
174
)
Wrought Iron Fence - Repair or Weld

Serving Locust Hill, VA and surrounding areas

Approved

In business since 1969

Free estimates

Emergency services offered

"I needed stucco repair work on an old chimney (and other spots). Grady was meticulous and thoughtful on what approaches and materials would work. Throughout the project they allocated sufficient time for each treatment to cure and inspected the work before proceeding to the next step. Grady started the project with no money down and only required ongoing payments for materials until the project was well underway. The final payment was due only after they did a final inspection. Total project cost was also below other bids."
Response time11 hrs
Response rate100%
Recommended by57%of homeowners
Showing 1-10 of 32
Welding questions, answered by experts

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

Yes, but you’ll need reliable steel-cutting tools and safety gear to get started. Shipping containers are typically around ¾ inch thick, so it’s entirely possible to cut through them, but experience and the right equipment are very important. When possible, try to get a container as close to the size you want it as possible.

Professional metal fabricators typically charge around $70 per hour, but the total cost of your project will depend on several factors. The largest cost drivers are the size, complexity, and design of the project, as well as the price and type of metal used. A good way to estimate the total cost is to multiply the cost of raw materials by four; typically, one-quarter of the total goes toward materials and three-quarters toward labor. Your geographic location can also influence costs, as labor and material prices vary by region.

It will likely take an experienced pro less than an hour to install a ground rod, which is another reason why letting them handle the job is such a good idea. Safety concerns aside, it would likely take you much longer to install a ground rod if you decided to take this one as a DIY job.

Yes, you can use a saw to cut metal pipes. The best saw to use is a reciprocating saw, but even a fine-tooth hacksaw can get the job done. No matter which saw you use to cut metal pipes, wear protective gear, like work gloves, safety goggles, and ear plugs. Apply a firm, steady pressure to the tool, and always ensure the pipes are secured so they don't move while you make the cuts.

The Locust Hill, VA homeowners’ guide to welding services

From average costs to expert advice, get all the answers you need to get your job done.