Get matched with top sink repair pros in Willard, UT

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.

Hiring an emergency plumber is expensive because of the urgency and inconvenience, but there are a few things you can do to help keep costs down:

• Minimize water damage by shutting off your water main 

• Clean up pooling water immediately to reduce damage and mold growth

• Avoid using fixtures if you have a clog or septic system backup

• Verify that your plumber is licensed before hiring

• Call a few plumbers for estimates if you can afford a short delay in getting service

Silicone caulk—despite having some adhesive properties—is not the primary thing that holds your sink in place. Rather, it seals the gaps around the sink to prevent water from leaking and causing issues with mold and corrosion. Most sinks are secured by clips, though some sinks are secured with two-part epoxy or brackets.

There are several types of sink drain stoppers, including pull-out, twist-and-pull, and pop-up. Pull-out sink stoppers can be removed by pulling on the stopper until it comes out of the drain. A twist-and-pull design requires lifting then turning the stopper to lock it in an open position and the opposite action (turning, then pressing down) to close it. A pop-up sink stopper works by pushing down the drain cover to open or close the passageway.