Get matched with top marble and granite pros in Central Vly, UT

Marble is high maintenance, like most other types of natural stone flooring. However, because it is naturally a more porous stone, there are a few added care instructions. You will need to clean it often to prevent dirt and grit from scratching the finish and surface, keep it dry, clean up spills immediately, and have it professionally sealed and refinished at least once a year to maintain the shine and water-tight surface. However, investing in maintenance is a smart move because marble floors are among the most beautiful and valuable types of flooring when properly cared for.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

You should always seal cut countertops to prevent damage and to keep them looking their best. The right way to seal countertops depends on the type of material. For laminate and wood, apply epoxy or other specialty sealers by pouring it onto the countertop and letting it flow across the whole surface to the edges, guiding it with a paint stick or putty knife. You will need to move quickly so that it does not dry or harden before you are done. For stone countertops, use a sealant specially manufactured for your type of stone and apply it according to manufacturer directions. 

You can cut countertops without chipping by using your saw correctly and having a new fine-toothed blade. You can also put masking tape on the front of the countertop material across the cut line and cut from front to back. However, it is very hard to cut countertops without chipping them, especially if they are made of stone or more fragile materials like laminate. The best advice is to know how to use the equipment, use the correct cutting method for the material, cut from back to front, move slowly, and practice on scrap material first.