Best concrete driveway pros near Ballard, UT

You can use a pressure washer to clean a whole host of surfaces. The exterior siding of your house is one of the most popular spots, as well as your driveway, garage floor, patio or deck, and even your outdoor furniture. Just be mindful about the amount of pressure you apply to different materials—concrete can handle a lot more than wood, for example.

Not pressure washing your driveway can lead to several consequences that affect both its appearance and its structural integrity over time:  

• Reduced Curb Appeal: A dirty driveway covered in grime, stains, and mildew detracts from your home's overall appearance.  

• Safety Hazards: The buildup of algae, moss, and mildew creates slippery surfaces. When wet, it increases the risk of slips and falls for you, your family, and visitors.  

• Structural Damage: Dirt, debris, and organic growth can trap moisture against the driveway's surface. In colder climates, this moisture can freeze and thaw, leading to cracks and deterioration of the concrete or asphalt.

Some homeowners have luck using pressure washers, but this only works for old or weaker concrete sealants and with very powerful pressure washers. You’ll get better results by pressure washing water-based sealants. However, it’s worth trying on any sealant if you’re hoping for the least toxic, least expensive, and most DIY-friendly option. To try this method, rent or buy the most powerful pressure washer you can find and take several passes at the concrete, completely pressure washing the entire area. You may need to repeat the process multiple times to see results.

Whether you need to winterize your pressure washer depends on where you store it. If you can keep it in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, if the machine will be stored in freezing temperatures, any liquid left in the water pump can freeze, expand, and cause severe damage. To prevent this, add antifreeze to keep it in good condition. While some suggest emptying the machine with compressed air, this can be a tedious process that may not fully drain the liquid. Regardless of storage conditions, it is also good practice to empty the gas chamber and refresh the oil before winter storage.