Get matched with top concrete driveway pros in Provo, UT

Does the water in your taps sometimes come out very slowly? If so, you might have problems with low water pressure in your house, and your pressure washer won’t effectively clean. To test if your water pressure is sufficient, time how long it takes for the water from your hose to fill a 5-gallon bucket. Usually, if it takes less than two minutes, you’re good to go.

Whether you need to winterize your pressure washer depends on where it will be stored. If it's kept in a location where temperatures could drop to freezing, any liquid left in the water pump can freeze, expand, and cause severe damage to the machine. To prevent this, you can add antifreeze to the pump. While emptying the machine with compressed air is an alternative, it can be a tedious process and may not remove all the liquid. If you can store the pressure washer in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, regardless of storage conditions, it is good practice to empty the gas chamber and refresh the oil before storing it for the winter.

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

Some homeowners have luck using pressure washers, but this only works for old or weaker concrete sealants and with very powerful pressure washers. You’ll get better results by pressure washing water-based sealants. However, it’s worth trying on any sealant if you’re hoping for the least toxic, least expensive, and most DIY-friendly option. To try this method, rent or buy the most powerful pressure washer you can find and take several passes at the concrete, completely pressure washing the entire area. You may need to repeat the process multiple times to see results.