Get matched with top water heater pros in Austin, UT

Installing a water heater without a permit can result in high fines—as much as hundreds of dollars per day, in some areas. It can also void your homeowners' insurance and cause problems when selling your home because it violates local building codes and safety regulations.

Depending on the brand of water heater, you may need to install an expansion tank in order to meet the conditions for warranty coverage. It’s important for consumers to read the fine print of the warranty to see if an expansion tank is necessary. Even if an expansion tank isn’t required for the warranty, it’s usually mandated by building codes—although not for tankless water heaters.

The average cost to install a new water heater is approximately $1,300, with a typical price range between $880 and $1,800. The final cost depends on several factors, including the type and size of the unit, its location and accessibility, and the amount of labor required. For example, installing a unit in a tight space like a crawl space can increase labor costs. The type of water heater significantly impacts the price: while a conventional gas heater might cost less than $1,000, tankless models can cost around $2,600 to install (and up to $3,500), and solar heaters can cost upwards of $3,700. Other factors that can affect the total price include the fuel type, vent system requirements, permits, and whether any additional plumbing work or repairs from previous water heater damage are needed.

No, you’ll need to drain the tank before changing a water heater element, as the water heater element sticks through the side of the tank and uses a gasket to prevent water from pouring out. However, you don’t always need to drain it completely. If you’re only replacing the upper heating element, you can drain the tank until the water line is below the element. If you’re replacing the lower element, you’ll need to drain the whole thing.