Get matched with top drywall pros in Zavalla, TX

Deciding whether to repair or replace drywall can be tricky, but your top considerations should be the extent of the damage and what caused the damage. For instance, if you need to repair a small hole caused by a doorknob that hit the wall, you can safely patch it without a second thought. However, if you have significant drywall damage caused by water damage, it’s best to thoroughly remove the drywall to inspect and repair the pipes behind it before replacing it.

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Whether you can reuse a drywall anchor or not depends on the type. Plastic expansion anchors and plastic self-drilling anchors, which expand once screwed into the wall, are single-use only. You can't straighten and reuse them after removing them from the wall.

Metal toggle bolts can be reused, provided you can successfully remove the toggle from behind the wall. Once you remove the bolt, the toggle often falls down and can be difficult to retrieve without removing the drywall.

You should stagger drywall sheets to help prevent cracking. The joints between drywall sheets are the weak spots, so if you install drywall with seams aligned, you’ll create weak lines that run across the length of the wall and extend from floor to ceiling. But when you stagger drywall, the solid sections of panels will support the joints. This can prevent seams from cracking or separating due to fluctuating temperature and humidity, vibrations from movement inside the home, and gravity.