Get matched with top metal fabricators and restorers in Vidor, TX

After Hurricane Laura in 2020, our church—North Orange Baptist—suffered major roof and water damage. On a trusted recommendation, we called Tim Warner with Univera Construction. From day one, Tim personally guided us through every phase of cleanup, restoration, and rebuilding. Even while helping...

Workermens Llc, provides Services of Bathroom Remodeling, Kitchen Remodeling, Painting, Flooring roofing and siding services to repair and installation of fencing, to improve the appearance of your home or business Services Provided Attic Restoration, Bathroom Remodeling, Carport Installation,...

They were awesome. Installed on front of house. Then hired again to install around rest of house. Very professional and work is very well done.

One day while sitting in my living room I heard a loud pop noise. I went outside and saw the front of my house had a 1 inch wide crack at the corner from the ground all the way up the wall on two sides. Like the entire corner was about to fall off the house. I made a few phone calls and someone...

I was very impressed at the attention to detail these guys adhere to. They use all Heavy Gauge material. They are extremely meticulous. I HIGHLY recommend Scott Lambert and his crew for all your metal structure projects.

Clay was one of the few people who I could get to call me back in Selma, and he is the only one who showed up when he said he would. We were moving to Selma and bought a house with a fair bit of damage to the walls both in the sheetrock and the trim.  We wanted someone to repair the walls and...

When the workers came out, they said that cat litter was everywhere and they couldn’t clean the apartment because it would damage their equipment. I have my own vacuum and offered to use it before they started cleaning. Once they saw the litter they basically just up and left without even...

The work that was performed was sloppy and unprofessional.  It started by Mr Hillin ordering 80 squares of metal, when our roof only required 62 squares.  When he completed the job there were 13 squares of untouched, uncut metal sheets left over,   There were another 5 sheets (1 square total)...