Top-rated masons.

Get matched with top masons in Tatum, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Tatum, TX?

Select your specific project to find the pro for you.

Find Masons in Tatum

Avatar for R&M masonry
R&M masonry
5.0(
8
)
Brick, Stone or Block Wall - RepairRetaining Wall - InstallBrick and Stone Flatwork - Repair+4 more

Serving Tatum, TX and surrounding areas

Approved

Super Service Award Winner

In business since 2025

Free estimates

Offers commercial services

"The brick layers were very knowledgeable and experienced. They corrected an alignment problem I wasn't even aware of. They finished the project in three hours and I was very pleased with the results. They suffered through the rain to keep working. I would highly recommend R&M Masonry for any stone or brick project."
Brick work
Brick work
Brick work
Brick work
Brick work

+18

Response time1 day
2 neighbors recently requested a quote
Avatar for Mores masonry
Mores masonry
New to Angi
Brick, Stone or Block Wall - InstallBrick and Stone Flatwork - RepairBrick and Stone Patios, Walks, and Steps - Install+5 more

Serving Tatum, TX and surrounding areas

Approved

Free estimates

Emergency services offered

Small jobs welcome

Hello customers, \n\nMore’s Masonry is a masonry company ready for the job at all times. We focus on brick, stone, and block. We also offer repairing services. We are trustworthy and reliable with friendly workers that are ready to take on a challenge. We are located in Jacksonville, Texas but can travel to where you need us. \n\nThank you, \nMore’s Masonry

Columns
Columns
House project
1 neighbors recently requested a quote
...
Showing 1-10 of 142
Masonry questions, answered by experts

You will repoint over a fraction of the old mortar, but you should scrape away 1/2 to 1 inch of mortar from the joints before repointing. Otherwise, the repointing is only masking the weakened mortar instead of actually replacing it, which could put your chimney at risk of bigger, more expensive damages later on.

Yes, you can limewash surfaces other than brick. Plaster, stone, stucco, and concrete can all also be limewashed. Any porous surface that will absorb the wash is a good candidate for limewash, although it won’t help much with waterproofing. If you choose to limewash over paint, you’ll need to prep before applying it to avoid a powdery, chalky finish. Shiny surfaces like metal or glass can’t absorb limewash, so it’s not suited for these.

Landscape boulders, especially porous stones like sandstone or granite, can crack or break over time. Cracks occur when water seeps into the surface of the stone and freezes. The risk is highest when it rains during the day and temperatures freeze overnight since the moisture has time to penetrate deeper into the rock before expanding.

A traditional rectangular brick that is used for siding, brick walks, and pathways is 8 inches long by 4 inches wide. If you are shopping for fire bricks, the standard dimension is typically 9 inches long by 4.5 inches wide.

Fireclay is a type of clay but it is a type of clay that, because of its chemical composition, can be fired at a much higher temperature than other clays. This results in a denser and more heat-resistant final material. Because of the high percentage of a mineral called kaolin, fireclay sinks are smoother and more durable than other clay types.

The Tatum, TX homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.